Yenista Optics OSICS, Руководство пользователя

Страница: 201 / 252

Using the OSICS T100 Module
OSICS User Manual 201
BKR
TL
S-50
AT
N
DFB
ECL
T10
0
SL
D
SW
T
TLS
-A
G
SW
T
A
PC
MA
IN
moves to a second wavelength in the tuning range and displays the power level
corresponding to the calibration data.
Figure 155: T100 Unit Setup – Power calibration, power value at second wavelength
8. Measure the power level at the second wavelength on the power meter.
A valid power value can range from 0.6 mW to 1.2 mW.
9. Enter the power value measured by the power meter in this field and select ENTER .
A confirmation message appears.
10. Press the knob to confirm.
The message
Moving...
appears while the power value is set. The power calibration
is now complete and the values are stored in the module's non-volatile memory.
The T100
Unit Setup menu is displayed.
The new calibration data sets the new system calibration default.
13.9.4 Asking for a Factory Recalibration
Subject To externally verify the performance of the OSICS, refer to the procedure described in
section Performing a Wavelength Reference Calibration, p. 198 and section Performing a
Power Calibration, p. 200 . If the performance does not meet warranted specifications, a
complete calibration of the instrument may be required.
We recommend performing factory calibration of OSICS T100 modules over one-year
intervals.
Procedure Contact the Y enista Optics customer support service (see section Contact Information,
p. 4 ) for a complete calibration, as some calibration steps require the adjustment of
internal components including the laser head.
Main
EXIT
2 3 4 5 6 7 8
ECL Unit Setup - Power calibration
ESCAPE
Second power value :
Correct the value.
ENTER
1
▲
P = +09.160 dBm
Second wavelength : 1590.000 nm.