Yenista Optics OSICS, Руководство пользователя

Страница: 103 / 252

Using the OSICS ECL Module
OSICS User Manual 103
BKR
TL
S-50
AT
N
DFB
ECL
T10
0
SL
D
SW
T
TLS
-A
G
SW
T
A
PC
MA
IN
9.2 Enabling/Disabling the Light Source of the Module
Subject You can enable/disable the light source in two different ways:
• From the OSICS Mainframe Main Setup menu (see section Enabling/Disabling the
Light Source of All Modules, p. 37 ), you can simultaneously enable or disable the light
source in all the modules installed in the OSICS Mainframe. This function overrides
the enable/disable state individually set in all modules.
• From the ECL front panel, you can individually enable or disable the light source of
the module by using the Enable button as explained in the following procedure. This
action does not affect the enable/disable state of other modules installed in the
OSICS Mainframe.
For laser safety reasons, the light source in modules are disabled after OSICS initialization.
Before Starting Connect an optical device to the OSICS module (see section Connecting Optical Devices
to OSICS Modules, p. 26 ).
Procedures Enabling the Light Source of the Module
• On the ECL module front panel press the Enable button.
The green LED on the button is lit.
In the System Status screen, the output power is displayed in the P field (in dBm or
mW depending on the selected power unit) for the corresponding module.
Disabling the Light Source of the Module
• On the ECL module front panel press the Enable button.
The green LED on the button is turned off.
In the System Status screen, the message Disabled is displayed for the
corresponding module.
• Do not enable the laser while there is no fiber connected to the
optical output connector.
• Do not look directly into the fiber end of an optical cable connected
to any optical output while the device is in use. This may cause
permanent eye damage.
WARNING