Rocker Switch Replacement Kit - 93117
For 115VAC/60Hz & 100VAC/50Hz Vacuum Pump Motors
CAUTION
•
Always unplug the motor from the power source before
performing any service.
•
A dielectric withstand test should be performed using a hipot
tester after any repairs to ensure proper wiring and continuity
per IEC 60950.
Kit Contents
- Rocker Switch
- (2) Red Wires
- Blue Wire Nut
Tools Required
-
¼” Nut Driver
- Pliers
- Wire Stripper (for
100V/50Hz)
- Electrical Tape (for
100V/50Hz)
Instructions for Rocker Switch Replacement
1. Unplug the motor from the power
source.
2. Remove the (2) screws that hold the
rocker switch plate to the motor body
using a ¼” nut driver
3a. For 115V/60Hz models with spade terminals on the back of the rocker switch:
i. Pull the 2 connectors off of the switch spade
terminals.
ii. Compress the locking tabs on the sides of the
rocker switch.
iii. Press the switch out through the front of the switch
plate.
iv. Press the new rocker switch into the plate.
v. Reconnect the 2 spade connectors to the back of
the rocker switch (wire nut and red wires are not
needed).
Rocker Switch Replacement Kit - 93117
For 115VAC/60Hz & 100VAC/50Hz Vacuum Pump Motors
CAUTION
•
Always unplug the motor from the power source before
performing any service.
•
A dielectric withstand test should be performed using a hipot
tester after any repairs to ensure proper wiring and continuity
per IEC 60950.
Kit Contents
- Rocker Switch
- (2) Red Wires
- Blue Wire Nut
Tools Required
-
¼” Nut Driver
- Pliers
- Wire Stripper (for
100V/50Hz)
- Electrical Tape (for
100V/50Hz)
Instructions for Rocker Switch
Replacement
3. Unplug the motor from the power
source.
4. Remove the (2) screws that hold the
rocker switch plate to the motor body
using a ¼
” nut driver
3a. For 115V/60Hz models with spade terminals on the back of the rocker switch:
i. Pull the 2 connectors off of the switch spade
terminals.
ii. Compress the locking tabs on the sides of the rocker
switch.
iii. Press the switch out through the front of the switch
plate.
iv. Press the new rocker switch into the plate.
v. Reconnect the 2 spade connectors to the back of
the rocker switch (wire nut and red wires are not
needed).