TB200/400 User Manual
6/39
Calls from SIP to BRI
1) Configure a route on TB200/400; choose the VoIP trunk in the field “Call
Comes in From”, and choose BRI trunk in the field “Send calls
Through”.
Enable Two-stage Dialing
on the route.
2) Make a call from your SIP server, dial the SIP account number which is
registered on TB200/400. You will hear a dial tone or two-stage dialing prompt,
then dial the external number out through BRI trunk.
Calls from BRI to SIP
1) Configure another route on TB200/400, choose BRI trunks in the field “Call
Comes in From”, and choose the SIP trunk in the filed “Send Calls Through”.
Enable Two-stage Dialing
on the route.
2) When an incoming call reaches BRI trunk on TB200/400, you will hear a dial
tone or two-stage dialing prompt, then dial an extension number of the SIP
server.
SPS Mode
(Recommended)
Create a Service Provider SIP trunk on TB200/400 to connect to your SIP server. Add
another Service Provider SIP trunk on your SIP server, connecting to TB200/400.
Calls from SIP to BRI
1) Create one outbound route on your SIP sever, and select the SIP trunk you
have created just now.
2) Configure a route on TB200/400, choose the SPS trunk in the field “Call
Comes in From”, and choose BRI trunk in the field “Send calls Through”.
3) Make a call from your SIP Server and the call should match the outbound
route dial rules.
Calls from BRI to SIP
1) Configure another route on TB200/400, choose BRI trunks in the field “Call
Comes in From”, and choose the SPS trunk in the filed “Send Calls Through”.
2) Create one inbound route on your SIP server and select the SIP trunk created
just now.
3) When an incoming call reaches BRI trunk on TB200/400, it will be routed to
the destination of the SIP server inbound route.
Note:
if you want the call to go directly to the destination number of your SIP
server, you don’t have to create an inbound route on SIP server, instead set a
Hotline
number on TB200/400 route.
Typical Application