MyPBX U300 Administrator Guide
93
Default Port: 21.
Hostname
Set the host name for MyPBX U300.
IP Address
Set the IP Address for MyPBX U300.
Subnet Mask
Set the subnet mask for MyPBX U300.
Gateway
Set the gateway for MyPBX U300.
Primary DNS
Set the primary DNS for MyPBX U300.
Secondary DNS
Set the secondary DNS for MyPBX U300.
IP Address2
Set the second IP Address for MyPBX U300.
Subnet Mask2
Set the second subnet mask for MyPBX U300.
WAN Settings
WAN port is disabled by default. Users should log in MyPBX to enable WAN. It
supports “DHCP Server”, “PPPoE/dynamic DNS”, and “Static IP” for IP address
assignment.
Note:
MyPBX does not act as a routerto route the internet packages from WAN port to
LAN port.
Figure 18-2WAN Settings
Table 18-2WAN Settings
Items
Description
DHCP
If your ISP says that you are connecting through DHCP or
a dynamic IP address, perform these steps:
Step1: Select
“DHCP” as theWAN Connection Type.
Step2: Save the changes.
Step3: Reboot the device.
Step4: Check the WAN Status (Status
Network status).
Static IP Address
If your ISP says that you are connecting through a static or
fixed IP address, perform these steps:
Step1:
Select “Static IP Address”as theWAN Connection