background image

Accessing the web user interface:

Account Settings:  

Click on

 Account

->

Register

->

Account X 

(X=1,2)

Parameters of the account:

Network Settings:

Account Settings:

Configuring via phone user interface

Configuring via web user interface

Configuring Your Phone

Register status icons on the LCD screen:

SIP-T21P

Enterprise IP Phone

Quick Installation Guide

www.yealink.com

Note: 

Please locate your computer in the same network segment of the IP phone (192.168.0.X) to access

          the web user interface. Contact your system administrator for more information.

Note: 

Check with your system administrator if any error appears during the registration process or a 

          specific configuration is required for your registration.

Note: 

The wrong network settings may result in inaccessibility of the phone and may have an impact on

          the network performance. Contact your system administrator for more information.

1. Press the 

OK

 key when the phone is idle to get the IP address of the phone. 

You can configure the network in the following ways:

It shows the register status of the current account.

You can select Enabled/Disabled to enable/disable the account.

It is shown on the LCD to identify the account.

It is shown as caller ID when placing a call.
It is provided by ITSP for registration (required).

It is an authenticated ID for authentication provided by ITSP (required).

It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).

DHCP

: By default, the phone attempts to contact a DHCP server in your network to obtain its 

           valid network settings, e.g., IP address, subnet mask, gateway address and DNS address.

Static IP Address

: If the phone cannot contact a DHCP server for any reason, you need to 

           configure IP address, subnet mask, gateway address, primary DNS address and 

           secondary DNS address for the phone manually.

PPPoE

: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE 

            mode. Contact the ITSP for the user name and password.

Press the 

Menu

 soft key when the phone is idle, select 

Settings

->

Advanced Settings 

(

password:admin

)->

Network

->

WAN Port/VLAN/Webserver Type/802.1x Settings/VPN

 to configure

 the network.

For more information, refer to the User Guide available online:

http://www.yealink.com/DocumentDownload.aspx?CateId=142&flag=142

Copyright     2013 YEALINK NETWORK TECHNOLOGY CO.,LTD.

Press the 

Menu

 soft key when the phone is idle, select 

Settings

->

Advanced Settings 

(

password:admin

)->

Accounts 

to configure the account. 

2. Open the web browser on your computer, enter the IP address into the address bar 

    (e.g., "http://192.168.0.10" or "192.168.0.10")

 

and press 

Enter

.

Register Status:            

Line Active:            

Label:                          

Display Name: 

User Name: 

Register Name: 

Password: 

Server Host: 

3. Enter the user name (default: admin) and password (default: admin) in the login page  

    and click 

Confirm

.

Network Settings:  

Click on

 Network

->

Basic

->

IPv4 Config

Note: 

For more information on account parameters, refer to 

 Configuring via web user interface

.

Registered

Register Failed

Registering

c

Applies to firmware version 71 or later.

Отзывы: