Yealink W60P Telesystem, Руководство администратора

Страница: 25 / 264

Administrator’s Guide for W60P/W53P/W41P DECT Phones
18
Permitted
Values
IPv4 Address
Default Blank
Web UI Network->Basic->IPv4 Config->Static IP Address->Primary DNS
Handset UI
OK->Settings->System Settings->Network (default PIN: 0000) ->Basic >IPv4->IP Address Type: DHCP-
>DNS Type: Manual->Primary DNS
DD Phone
UI
Menu->Settings->Advanced Settings (default password: admin)->Network->WAN Port->IPv4->Static
IPv4 Client->Pri.DNS
Or Menu->Settings->Advanced Settings (default password: 0000)->Network->WAN Port->IPv4->DHCP
IPv4 Client->Static DNS (Enabled) ->Pri.DNS
Parameter
static.network.secondary_dns
[1]
<y0000000000xx>.cfg
Description
It configures the secondary IPv4 DNS server.
Example :
static.network.secondary_dns = 202.101.103.54
Note : It works only if “static.network.ip_address_mode” is set to 0 (IPv4) or 2 (IPv4 & IPv6). In DHCP envir-
onment, you also need to make sure “static.network.static_dns_enable" is set to 1 (On).
Permitted
Values
IPv4 Address
Default Blank
Web UI Network->Basic->IPv4 Config->Static IP Address->Secondary DNS
Handset UI
OK->Settings->System Settings->Network (default PIN: 0000) ->Basic->IPv4->IP Address Type: DHCP-
>DNS Type: Manual->Secondary DNS
DD Phone
UI
Menu->Settings->Advanced Settings (default password: admin)->Network->WAN Port->IPv4->Static
IPv4 Client->Sec.DNS
Or Menu->Settings->Advanced Settings (default password: 0000)->Network->WAN Port->IPv4->DHCP
IPv4 Client->Static DNS (Enabled) ->Sec.DNS
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.
IPv6 Configuration
If you configure the network settings on the phone for an IPv6 network, you can set up an IP address for the phone by
using SLAAC (ICMPv6) or by manually entering an IP address. Ensure that your network environment supports IPv6.
Contact your ISP for more information.
The following table lists the parameters you can use to configure IPv6.
Parameter
static.network.ipv6_internet_port.type
[1]
<y0000000000xx>.cfg
Description
It configures the Internet port type for IPv6.
Note : It works only if “static.network.ip_address_mode” is set to 1 (IPv6) or 2 (IPv4 & IPv6).
Permitted
Values
0 -DHCP
1 -Static IP Address
Default 0