Yealink VC110, Руководство администратора

Страница: 64 / 268

Administrator‘s Guide for Yealink VC110 Video Conferencing Endpoint
52
the previous screen.
10. Configure network settings.
The phone will try to contact a DHCP server in your network to obtain network
parameters by default. If you uncheck the DHCP checkbox, you will need to
configure IPv4 or IPv6 network manually. For more information, refer to
Configuring
LAN Properties on page 56 .
11. Press (Complete soft key) to complete the setup wizard.

If you use Network Address Translation (NAT) to assign a public IP address to your
VC110 endpoint for communication with devices outside your private network, you
must enable NAT on your VC110 endpoint before placing calls. For more
information, refer to
Network Address Translation on page 90 .

If your VC110 endpoint communicates with other devices through a firewall, you
must configure your firewall to allow incoming and outgoing traffic to theVC110
endpoint through the reserved ports specified in
Reserved Ports on page 87 . And
the required ports specified in Configuring the Endpoint for Use with a Firewall or
NAT on page 87 . Users placing calls through a firewall to endpoints may
experience one-way audio or video if the firewall is not properly configured.

If you are using Session Initiation Protocol (SIP) servers in your environment to place
calls using the SIP protocol, refer to
Configuring SIP Settings on page 111 .

If you are using H.323 gatekeepers in your environment and want to place calls
using a name or extension with the H.323 protocol, refer to
Configuring H.323
Settings on page 115 .