Yealink SIP-T19 E2 T4 Series, Руководство администратора

Страница: 74 / 981

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/T5 Series IP Phones
52
IPv6 Support
Because Internet Protocol version 4 (IPv4) uses a 32-bit address, it cannot meet the increased
demands for unique IP addresses for all devices that connect to the Internet. Therefore, Internet
Protocol version 6 (IPv6) is the next generation network layer protocol, which designed as a
replacement for the current IPv4 protocol.
IPv6 is developed by the Internet Engineering Task Force (IETF) to deal with the long-anticipated
problem of IPv4 address exhaustion. Yealink IP Phone supports IPv4 addressing mode, IPv6
addressing mode, as well as an IPv4&IPv6 dual stack addressing mode. IPv4 uses a 32-bit
address, consisting of four groups of three decimal digits separated by dots; for example,
192.168.1.100. IPv6 uses a 128-bit address, consisting of eight groups of four hexadecimal digits
separated by colons; for example, 2026:1234:1:1:215:65ff:fe1f:caa.
VoIP network based on IPv6 can provide end-to-end security capabilities, enhanced Quality of
Service (QoS), a set of service requirements to deliver performance guarantee while transporting
traffic over the network.
If you configure the network settings on the phone for an IPv6 network, you can set up an IP
address for the phone either by using SLAAC (ICMPv6), DHCPv6 or by manually entering an IP
address. Ensure that your network environment supports IPv6. Contact your ISP for more
information.
IPv6 Address Assignment Method
Supported IPv6 address assignment methods:

Manual Assignment:
An IPv6 address and other configuration parameters (for example,
DNS server) for the IP phone can be statically configured by an administrator.

Stateless Address Autoconfiguration (SLAAC)/ICMPv6:
SLAAC is one of the most
convenient methods to assign IP addresses to IPv6 nodes. SLAAC requires no manual
configuration of the IP phone, minimal (if any) configuration of routers, and no additional
servers. To use IPv6 SLAAC, the IP phone must be connected to a network with at least one
IPv6 router connected. This router is configured by the network administrator and sends
out Router Advertisement announcements onto the link. These announcements can allow
the on-link connected IP phone to configure itself with IPv6 address, as specified in RFC
4862.

Stateful DHCPv6:
The Dynamic Host Configuration Protocol for IPv6 (DHCPv6) has been
standardized by the IETF through RFC 3315. DHCPv6 enables DHCP servers to pass
configuration parameters such as IPv6 network addresses to IPv6 nodes. It offers the
capability of automatic allocation of reusable network addresses and additional
configuration flexibility. This protocol is a stateful counterpart to “IPv6 Stateless Address
Autoconfiguration” (
RFC 2462 ), and can be used separately or concurrently with the latter
to obtain configuration parameters.