Page
8
of
27
Horizon
|
Yealink W52P Full User Guide
© Gamma 2016. All rights reserved. Confidential
How to set up the Yealink W52P
The phone will arrive pre-configured and simply needs to be connected to the internet and powered
up. Your Administrator or installer should know how to do this for you. There are some
network/router level settings that must be applied, or the Horizon service will not work. For further
details on these please refer to the Horizon user guide.
Up to 5 handsets can be registered to a Yealink W52P base station. Usually the handset that comes
in the same box with the base station is pre-associated with it. In case that the handset is not
already associated with the base station, or if you would like to associate more handsets that have
been purchased separately you can find the required steps below.
Register Handset
Press the
button on the base station for few seconds. Once the registration LED flashes
slowly, this means that the base station is in the registration mode.
Press “OK” on the handset to enter the main menu
Select Settings
Registration
Register Handset
Once you see the available base station, select it and press “OK”
Enter the registration PIN which
is 0000 and press “Done”
Note1: Once the handset is registered it will automatically get a name such as H1.
Note 2: In order to check that the registration was successful and the device is ready to
make/receive calls go to Main Menu
Status
Line Status
De-register Handset
In order to de-register a handset from the base station, follow the steps below:
Press “OK” to enter the main menu
Go to Settings
Registration
De-reg. Handset
Enter the PIN which is 0000 and press “Done”
Select the handset that you want to de-
register, press “OK” and then “Yes”
Note: You can de-register any handset that is associated with the base station
