Horizon
|
Yealink W52P Full User Guide
© Gamma 2016. All rights reserved. Confidential.
Page
23
of
27
Manual Registration
The repeater, base station and handset must be accessible before performing the registration. If
you want to register more than one repeater, the registration must be performed separately for each
repeater.
To register a repeater manually:
-
Set the repeater in registration mode.
-
Switch on the repeater for 1-5 seconds and then switch it off. Switch it on once more and
leave it there.
The LED indicator on the repeater flashes slowly. You now have five minutes to complete the
registration. If the registration is not completed within this period, you must start over again.
-
Set the base station in registration mode.
-
Long press the paging key on the base station till the first LED flashes.
-
The LED indicator on the repeater flashes.
If the LED flashes fast without interruptions, go to Assign a repeater number. If the LED flashes fast
with interruptions, go to Registration of handset.
-
Registration of handset.
You must re-register the handset even if the handset used was already registered to the base
station. Now the LED indicator flashes fast without interruptions.
-
Assign a repeater number.
You must now assign a repeater number to the repeater (choose from 2 to 7, for up to 6 repeaters):
-
Press #*9 and the off-hook key on the handset. The LED indicator illuminates.
-
Press a number between 2 and 7. When the repeater has accepted the chosen number,
the LED indicator will flash a corresponding number of times. If you miss the confirmation
flash, press the number again.
-
Accept the registration by pressing the * key, and then press the on-hook key. The
repeater is now automatically restarted: the LED indicator goes off for 2 seconds, flashes
for a brief moment and then stays illuminated. The registration of the repeater is
completed. You can now disconnect the power adapter and move the repeater to the
selected location (disconnecting the power will not clear the registration).
Note: Each number can be assigned only once when using more than one repeaters on a base
station. Repeater number and handset number are independent of each other.
