| Call Features |
18
8.
Repeat steps 5 to 7 until you add all parties.
Note:
The procedures for setting up a network conference call on specific servers may be different.
Contact your system administrator for more information.
Inviting another Party into an Active Conference Call
Any party in the conference call can invite other party into an active conference call.
1.
Select
Conference
or
Hold
>
New Call
.
2.
Enter the desired number and dial out.
3.
When the new party answers the call, select
Conference
.
The new party is joined the conference call.
Holding/Resuming a Conference Call
Any party in the conference call can place himself/herself on hold, but other parties can continue the conference call
normally.
Note:
The conference call will only be held when all parties in the conference call place themselves on hold.
1.
Select
Hold
.
2.
Select
Resume
to resume the held conference call.
Ending a Conference Call
You can end the current conference call at any time.
Press
or
End Call
.
Multicast Paging
Multicast Paging allows you to broadcast instant audio announcements to users who are listening to a specific
multicast group on a specific channel.
The phone supports the following 31 channels:
•
0
: Broadcasts are sent to channel 0.
•
1 to 25
: Broadcasts are sent to channel 1 to 25. We recommend that you specify these channels when broadcasting
with Polycom IP phones which have 25 channels you can listen to.
•
26 to 30
: Broadcasts are sent to channel 26 to 30. We recommend that you specify these channels when
broadcasting with Yealink IP phones running firmware version 81 or later running new firmware version (new
paging mechanism).
Note:
All IP phones in the multicast paging group must be deployed in the same subnet since a broadcast
is used. The phone can only send/receive broadcasts to/from the listened channels. Other channels’
broadcasts will be ignored automatically by the IP phone.
Sending Multicast Paging
You can send paging to the phones with pre-configured multicast addresses on specific channels.
Your system administrator has set the paging group for your phone.
1.
Go to
Menu
>
Features
>
Pagine List
.
If your system administrator has set only one paging list, the paging is sent directly.
2.
Select the desired paging group.
3.
Select
Paging
.
Note:
Multicast RTP is the one-way paging only from the sender to the multicast address(es) (receiver).
For outgoing RTP multicasts, all other existing calls on the phone will be placed on hold.
