Yealink CPE80, Руководство администратора

Страница: 84 / 321

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
68
A dialog box pops up to prompt that the settings will take effect after a reboot.
5.
Click
OK
to reboot the phone.
To configure IPv6 address assignment method via phone user interface:
1.
Select
Menu
->
Advanced
(default password: 0000) ->
Internet Configuration
.
2.
Select
IPv4 & IPv6
or
IPv6
from the
IP Mode
field.
3.
Press or to highlight
IPv6
and press .
4.
Select the desired IPv6 address assignment method.
If you uncheck the
DHCP
checkbox, configure the IPv6 address and other network
parameters in the corresponding fields.
5.
Press the
Save
soft key to accept the change.
The IP phone reboots automatically to make settings effective after a period of time.
To configure static DNS when DHCP is used via phone user interface:
1.
Select
Menu
->
Advanced
(default password: 0000) ->
Internet Configuration
->
IPv6
.
2.
Check the
DHCP
checkbox.
3.
Check the
Static DNS
checkbox.
4.
Enter the desired values in the
DNS Primary Server
and
DNS Secondary Server
fields
respectively.
5.
Press the
Save
soft key to accept the change.
6.
The display device prompts “Reboot now?”.
7.
Select
OK
to reboot the endpoint immediately.
Configuring Network Speed and Duplex Mode
You can configure the network speed and duplex mode the endpoint uses. The network speed
and duplex mode you select for the endpoint must be supported by the switch. The network
speeds and duplex modes supported by the endpoint are:

Auto

10 Mbps Full Duplex

100 Mbps Full Duplex

10 Mbps Half Duplex

100 Mbps Half Duplex
Auto is configured on the endpoint by default.
Auto
Auto means that the switch will negotiate the network speed and duplex mode for the
endpoints to transmit voice or data over Ethernet. This process entails devices first sharing
transmission capabilities and then selecting the highest performance transmission mode