YATO YT-84770, Руководство пользователя

Страница: 11 / 100

11
O R I G I N A L I N S T R U C T I O N S
EN
PRODUCT OVERVIEW
The hedge trimmer is used for trimming and shaping shrub crowns and trimming thin twigs. Thanks to the electric drive, the
trimmer is much quieter than a petrol one, and can also be used near buildings. Proper, reliable, and safe operation of the tool
depends on appropriate use, that is why you should:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be held liable for any damage or injury resulting from improper use of the tool, failure to observe the safety
regulations and recommendations of this manual. Using the tool for purposes other than those for which it was intended shall
cause the loss of the user’s rights to a warranty and statutory warranty.
PRODUCT EQUIPMENT
The tool is supplied complete and does not require assembly. A blade guard is supplied with the tool.
TECHNICAL DATA
Parameter Unit Value
Part no. YT-84770
Rated voltage [V~] 230 – 240
Rated frequency [Hz] 50
Rated power [W] 600
Cutting speed [min -1 ] 1700
Blade length / Cutting length [mm] 510 / 457
Max. cutting diameter [mm] 16
Electrical protection class II
Weight [kg] 3.0
Noise level
- L
pA
± K (pressure) [dB] (A) 91.0 ± 3.0
- L
wA
± K(power output) [dB] (A) 98.9 ± 3.0
Vibration, a
h
± K (front/rear handle) [m/s 2 ] 3.344 ± 1.5 / 4.308 ± 1.5
Protection rating IPX0
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Note! The vibration emission during tool operation may di ff er from the declared value, depending on the manner the tool is used.
Note! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of use (in-
cluding all parts of the work cycle, such as the time when the tool is switched o ff or idle and the activation time), must be speci fi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and speci fi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term “power tool” used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodi fi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the