YASKAWA
TOEP C720600 11B External Heatsink Installation Kit Installation Manual
31
■
Use the Mounting Bracket Included with the Drive (Procedure D)
Use the figures in this procedure to make sure that the orientation is correct, then install the
mounting bracket to the drive.
Cut an opening in the enclosure panel before you install the mounting bracket. Refer to
Mounting Dimensions and Panel Cut-out Dimensions on page 9
for more information.
1.
Remove the bolts from the bottom of the drive.
Note:
• Drive models HV60x2211, 2273, 4180, 4240, and FP65x4302 do not have these bolts on the bottom of the
drive.
• You will not use the removed bolts for installation.
A - Bolts
Figure 5.34 Remove the Bolts
2.
Remove the mounting bracket from the bottom of the drive.
A - Mounting bracket
Figure 5.35 Remove the Mounting Bracket
3.
Use the bolts included with the drive to install the removed mounting bracket to the
bottom of the drive in the position shown in
.
Tighten the bolts to a correct tightening torque:
• Drive models HV60x2143 to 2273, 4156 to 4240, and FP65x4302:
