4.2 Settings on Welding Source Panel
4-7
HW0480311
HW0480311
(5) Press the button “PRM Set”, and the parameter value on the 7-segment LED indi-
cator
e
“Wire m/min” blinks. The set value of parameter is ready to be changed.
Change the set value in the range between 10 and 200 %.
For changing the parameter number, press the button
“PRM Set” again.
The blinking digits move as shown below with each pressing of the button
“PRM
Set”.
(6) After changing the value, press the button
j
“PRM Set” or leave it without doing
anything for 10 seconds to return to the standby display.
Press the button
"Record" for three seconds or more to save the changed values
(conditions). Do not turn OFF the welding source during saving conditions. When
the 7-segment LED indicators are lit again, the saving of conditions is completed.
4.2.4
Changing Common (C) Parameters
For the details on the common parameter, refer to " 4.4 List of Common Parameters ".
The C parameter is the common parameters for the welding source.
Follow the instructions to change C parameter value as follows:
(1) Press the button
k
"Common PRM Select" during standby status. The 7-segment
LED indicator
c
voltmeter (V) displays "C.00" blinking, and the 7-segment LED indi-
cator
e
"Wire m/min" (WF) displays the parameter value lighting.
(2) Press the button
"L" or "R" to change the number of blinking digits to one. Press
the button
"L" to move the blinking to the left, and press the button
"R" to
move the blinking to the right.
(3) Using the button
"L" or "R", move the blinking digits to the number to be changed.
(4) Use the button
"+" or "-" to increase or decrease the value.
(5) Press the button
"PRM Set", and the parameter value on the 7-segment LED
11
11
11
V
A
Wire m/min
Type
V
A
Wire m/min
Type
14
13
13
13
13
13
11
41/129
