YASKAWA SGMAH, Руководство пользователя

Страница: 108 / 488

Sigma II User’s Manual Chapter 5: Parameter Settings and Functions
5 - 24
Use SEN to BAT (-) signals for absolute encoders. See 5.7 Absolute Encoders for
more details .
SG: Connect to 0V on the host controller.
Pulse Divider Setting
Set the pulse dividing ratio in the following parameter.
Set the number of pulses for PG output signals (PAO, /PAO, PBO, /PBO).
Input SEN CN1-4 SEN Signal Input Speed/Torque Control
Input /SEN CN1-2 Signal Ground Speed/Torque Control
Output PSO CN1-48 Encoder Output Phase S
Speed/Torque Control,
Position Control
Output /PSO CN1-49 Encoder Output Phase /S
Speed/Torque Control,
Position Control
Input BAT (+) CN1-21 Battery ( + )
Speed/Torque Control,
Position Control
Input /BAT (-) CN1-22 Battery (-)
Speed/Torque Control,
Position Control
Output SG CN1-1 Signal ground
Speed/Torque Control,
Position Control
• When using the servo amplifier phase C pulse signal to return to the machine origin, always turn the
servomotor at least twice before starting the original return operation.
If the configuration of the mechanical system prevents turning the servomotor before the origin return
operation, then perform the origin return operation at a servomotor speed of 600rpm or below. The phase C
pulse signal may not be correctly applied if the servomotor turns faster than 600rpm.
Parameter Signal
Setting
(PPR)
Control Mode
Pn201 PG Divider
Range: 16 to 16384
Default Setting: 16384
Speed/Torque Control,
Position Control
IMPORTANT
Output terminals: PAO (CN1-33)
/PAO (CN1-34)
PBO (CN1-35)
/PBO (CN1-36)
Phase A
Phase B
Output
Servo Amplifier
Servomotor
encoder
Serial
data
PG
Frequency
division