YASKAWA SGDV SERVOPACK, Руководство пользователя

Страница: 85 / 398

www.dadehpardazan.ir 88594014-15
3 Wiring and Connection
3.4.2 Sequence Input Circuit
3-32
3.4.2
Sequence Input Circuit
(1) Photocoupler Input Circuit
CN1 connector terminals 40 to 47 are explained below.
The sequence input circuit interface is connected through a relay or open-collector transistor circuit. When
connecting through a relay, use a low-current relay. If a low-current relay is not used, a faulty contact may
result.
Note: The 24 VDC external power supply capacity must be 50 mA minimum.

For SEN input signal circuit, refer to 5.9.1 Absolute Data Request Signal (SEN).

The SERVOPACK’s input circuit uses bidirectional photocoupler. Select either the sink circuit or the source
circuit according to the specifications required for each machine.
Note:  The connection examples in 3.2.3 to 3.2.5 show sink circuits.
• The ON/OFF polarity differs between when a sink circuit is connected and when a source circuit is connected.
Relay Circuit Example Open-collector Circuit Example
Sink Circuit Source Circuit
Input Signal Polarities Input Signal Polarities
Signal Level
Voltage
Level
Contact Signal Level
Voltage
Level
Contact
ON
Low (L)
level
0 V Close ON
High (H)
level
24 V Close
OFF
High (H)
level
24 V Open OFF
Low (L)
level
0 V Open
3.3 k
Ω
/S-ON, etc.
SERVOPACK
24 VDC
+24 VIN
24 VDC
3.3 k
Ω
/S-ON, etc.
SERVOPACK
+24 VIN
24 V
+
−
SERVOPACK input
24 V
+
−
SERVOPACK input