7
Disassembly and Reassembly of the Speed Reducers
7.1
Disassembly and Reassembly of S-Axis Speed Reducer
7-1
HW1485471
HW1485471
7
Disassembly and Reassembly of the Speed Reducers
7.1
Disassembly and Reassembly of S-Axis Speed Reducer
• Refer to
fig. 7-1(a) “Disassembly and Reassembly of the S-Axis
.
Disassembly
1. Turn OFF the power supply of the YRC1000.
2. Disconnect the internal wiring harness of only the rotating part of the
3. Remove the S-axis motor
Reassembly of the S-Axis Motor”
4. Unscrew the hexagon socket head cap screws
, and remove the
gear unit.
5. Unscrew the hexagon socket head cap screws
, and insert the stud
bolt M10 (length: 50 mm or more) into the tapped hole M10 (2 places)
on the S-head. Screw the stud bolt into the tapped hole until clearance
is made between the contact surface of the S-head and the speed
reducer .
6. Lift up the upper part of the manipulator including the S-head, and put
it down next to the base.
7. Unscrew the GT-SA bolts
, and then remove the cover
.
8. Unscrew the hexagon socket head cap screws
, and insert the stud
bolt M12 (length: 35 mm or more) into the tapped hole M12 (2 places)
on the speed reducer
. Screw the stud bolt into the tapped hole
until the clearance is made between the contact surface of the base
and the speed reducer
.
9. Mount the eyebolts diagonally on the tapped hole M16 (2 places) on
the speed reducer
. Remove the speed reducer
vertically by
using the eyebolts. At this time, remove the O-ring
.
10. Unscrew the hexagon socket head cap screws
, and remove the
shaft
and the O-ring
.
11. Remove the old sealing bond on the S-head and base.
NOTE
Refer to
chapter 3 “Home Position Return”
“Notes on Grease Replenishment/Exchange Procedures”
and
chapter 5.2 “Removing, Applying, Assembling of Seal-
Remove old sealing from each part before starting reas-
sembling.
5
13
2
1
11
10
3
1
1
1
1
4
8
7
9
64/134