4 Connections
4-1
168283-1CD
168283-1CD
Hardware Installation &
Software Upgrade
4
Connections
WARNING
•
The system must be grounded.
Failure to ground equipment may result in injury from fire or electric
shock.
•
Before wiring, make sure to turn OFF the primary power supply, and
put up a warning sign. (ex. DO NOT TURN THE POWER ON)
Failure to observe this caution may result in injury and electric
shock.
•
Do not touch any board inside the drive panel for five minutes after
turning OFF the power supply.
Capacitors inside the drive panel store electricity after power is
turned OFF. Exercise caution whenever handling circuit boards.
Failure to observe this caution may cause electrical shock.
•
Power cannot be turned ON unless the door is closed. Interlocks
prevent power from being turned ON.
Failure to observe this caution may result in fire and electric shock.
•
Any occurrence during wiring while the MLX200 is in the emergency
stop mode is the user’s responsibility. Do an operation check once
the wiring is completed.
Failure to observe this caution could lead to injury or mechanical
failure.
CAUTION
•
Wiring must be performed only by authorized personnel.
Incorrect wiring may cause fire and electric shock.
•
Perform wiring in accordance with the rated capacity as specified in
the Instructions.
Incorrect wiring may cause fire or mechanical breakdown.
•
Be sure the power circuit screws are securely tightened.
Loose power circuit wires can cause fire and electric shock.
•
Do not handle the circuit board directly by hand.
The IC board may malfunction due to electrostatics.
39 of 121
