YASKAWA GA800 Series, Руководство по программированию

Страница: 563 / 644

Keypad
Use
and
T
est
Run
3
3.4 Keypad Operation
YASKAWA TOEPYAIGA8002B GA800 Drive Programming 563
4.
Push or to select [Trend Plot], then push .
The screen will show the monitors as shown in this figure.
Note:
Push (Hold) to switch between Pause and Restart for the monitor display. The
“
Hold (ENTER)
”
message flashes while monitoring is
paused.
◆
Change Parameter Settings
This example shows how to change the setting value for C1-01 [Acceleration Time 1] . Do the steps in this procedure
to set parameters for the application.
1.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown above the , push (Back).
2.
Push (Menu).
3.
Push or to select [Parameters], then push .
4.
Push or to select [C Tuning], then push .