YASKAWA GA800 Series, Руководство по программированию

Страница: 557 / 644

Keypad
Use
and
T
est
Run
3
3.4 Keypad Operation
YASKAWA TOEPYAIGA8002B GA800 Drive Programming 557
The screen will show the monitors as shown in this figure.
◆
Set the Monitors to Show as Analog Gauges
The procedure in this section shows how to show the frequency reference monitor as an analog gauge.
1.
Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back) to show [Home] on .
2.
Push (Menu).
3.
Push or to select [Monitors], then push .
4.
Push or to select [Analog Gauge], then push (Setup).
5.
Push .
6.
Push or to select the monitor number to register, then push .
Enter the three digits in “x-xx” part of monitor Ux-xx to identify which monitor to output. For example, to show
monitor U1-01 [Frequency Reference] , set it to "101" as shown in this figure.