YASKAWA GA800 Series, Техническое обслуживание и устранение неисправностей, Страница: 453 / 566

Startup
Procedure
and
T
est
Run
6
6.6 Keypad Operation
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting 453
•
When there are a minimum of two screens, push or to switch between screens.
•
If you registered only one custom monitor to [Custom Monitor 1], the screen will show only one monitor. If you
registered custom monitors only to [Custom Monitor 1] and [Custom Monitor 2], the screen will show only two
monitors.
◆
Set the Monitors to Show as a Bar Graph
The procedure in this section shows how to show the frequency reference monitor as a bar graph.
1.
Push [Home] to show the HOME screen.
Note:
• The keypad will [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push [Back] to show [Home] on .
2.
Push [Menu].
3.
Push or to select [Monitors], then push .
4.
Push or to select [Bar Graph], then push [Setup].
5.
Push or to select the location to store the monitor, then push .