3.2 Operating Procedures for Utility Functions
3.2.38 ZONE Table Initialization (FnB07)
3-122
3.2.38
ZONE Table Initialization (FnB07)
This function initializes ZONE tables and restores the settings on ship-
ment from the factory.
Preparation
Always check the following before you initialize a ZONE table.
•
The parameters must not be write-prohibited (Fn010 must be set to
0000).
•
A ZONE table save operation must not be in progress for any means
other than the digital operator.
•
Execution of the RES command must not be in progress.
Operating Procedure
Step
Operation
Result
1
Press the
key to open the Util-
ity Function Mode main menu, and
move the cursor with the
keys to select FnB07.
2
Press the
key to view the
FnB07 operation screen.
3
Press the
key to start ZONE
table initialization.
*
Do not turn off the control power
supply until initialization has been
completed normally.
To cancel the FnB07 operation,
press the
key before pressing
the
key. The display returns to
the Utility Function Mode main
menu without executing the opera-
tion.
Continued on next page.
㹀㹀ࠉࠉࠉࠉࠉ㹄㹓㹌㹁㹒㹇㹍㹌
㹄㹬㹀㸮㸴ࠉ㹎㹅㹋ࠉ㹇㹬㹧㹲
㹄㹬㹀㸮㸵ࠉ㹘㹍㹌㹃ࠉ㹇㹬㹧㹲
㹄㹬㹀㸮㸶ࠉ㹈㹑㹎㹂ࠉ㹇㹬㹧㹲
㹄㹬㹀㸮㸷ࠉ㹘㹑㹃㹒
㹀㹀ࠉࠉࠉࠉࠉ㹘㹭㹬㹣㹇㹬㹧㹲
ࠉ㹑㹲㹟㹰㹲ࠉ㸸㹙㹂㸿㹒㸿㹛
ࠉ㹐㹣㹲㹳㹰㹬㸸㹙㹑㹃㹒㹛
㹀㹀ࠉࠉࠉࠉࠉ㹘㹭㹬㹣㹇㹬㹧㹲
㹐㹣㹱㹲㹭㹰㹧㹬㹥ࠉ㹬㹭㹵㸬㸬㸬
㹎㹪㹣㹟㹱㹣ࠉ㹵㹟㹧㹲㸬
