3.2 Operating Procedures for Utility Functions
3.2.24 Reset Motor Type Change Detected Status (Fn021)
3-60
3.2.24
Reset Motor Type Change Detected Sta-
tus (Fn021)
After an A.070 (Motor Type Change Detected) alarm occurs, you must
reset the Motor Type Change Detected status.
Preparations
Always check the following before you reset the Motor Type Change
Detected.
•
The parameters must not be write-prohibited (Fn010 must be set to
0000).
•
An A.070 (Motor Type Change Detected) alarm must have occurred.
Operating Procedure
Step
Operation
Result
1
Press the
Key to display the
Utility Mode Main Menu, and then
use the
Key or
Key to
select
Fn021
.
2
Press the
Key.
The Motor Type Change Detected
status will be reset.
When processing has been com-
pleted, the status display will flash
DONE
for approximately one sec-
ond and then return to
1:A.070
.
3
Press the
Key.
The display will return to the Utility
Mode Main Menu.
4
Turn the SERVOPACK power sup-
ply OFF and ON again.
The parameter setting is now
enabled and the alarm will have
been cleared.
1 : A . 0 7 0 F U N C T I O N
F n 0 2 0 :
S
- O r i g
S
e t
F n 0 2 1 : M o t o r
l n i t
F n 0
3
0 :
S
o f t R e
s
e t
F n 0 8 0 : P o l e D e t e c t
1 : A . 0 7 0
M o t o r C o n n e c t
H i
s
t r y l n i t
S
t a r t : [ D A T A ]
R e t u r n : [
S
E T ]
1 : A . 0 7 0 F U N C T I O N
F n 0 2 0 :
S
- O r i g
S
e t
F n 0 2 1 : M o t o r
l n i t
F n 0
3
0 :
S
o f t R e
s
e t
F n 0 8 0 : P o l e D e t e c t
