YASKAWA CR700, Техническое руководство, Страница: 691 / 886

Parameter
Details
11
11.8 H: Terminal Functions
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual 691
Note:
Refer to Setting Procedures for Multi-step Speed Operation on page 622 for more information.
■
5: Multi-Step Speed Reference 3
Setting Value Function Description
5 Multi-Step Speed Reference
3
Uses speed references d1-01 to d1-16 to set a multi-step speed reference.
Note:
Refer to Setting Procedures for Multi-step Speed Operation on page 622 for more information.
■
6: Jog Reference Selection
Setting Value Function Description
6 Jog Reference Selection
Sets the drive to use the JOG Frequency Reference (JOG command) set in d1-17 . The JOG Frequency command overrides
Frequency References 1 to 8 (d1-01 to d1-08] .
■
7: Accel/Decel Time Selection 1
Setting Value Function Description
7 Accel/Decel Time Selection
1
Sets the drive to use Acceleration/Deceleration Time 1 [C1-01, C1-02] or Acceleration/Deceleration Time 2 [C1-03, C1-04] .
Note:
Refer to
C1: Accel & Decel Time on page 600
for more information.
■
8: Baseblock Command (N.O.)
Setting Value Function Description
8 Baseblock Command (N.
O.)
Sets the command that stops drive output and coasts the motor to stop when a baseblock command (N.O.) is input.
The keypad flashes bb [Baseblock] . Acceleration always starts from the zero speed when the Run command is
input. The drive keeps the baseblock state when the Run command is not input.
WARNING!
Sudden Movement Hazard. When you use a mechanical holding brake with the drive in a lifting application, you
must close the brake if an input terminal triggers the Baseblock command to stop drive output. If you enter the baseblock
command, the motor will suddenly coast and the load will slip, which can cause serious injury or death.
Figure 11.51 Baseblock Command Time Chart
ON : Baseblock (drive output stop)
OFF : Normal operation
■
9: Baseblock Command (N.C.)
Setting Value Function Description
9 Baseblock Command (N.
C.)
Sets the command that stops drive output and coasts the motor to stop when baseblock command (N.C.) is input (turned OFF).
The keypad flashes bb [Baseblock] .
WARNING!
Sudden Movement Hazard. When you use a mechanical holding brake with the drive in a lifting application, you
must close the brake if an input terminal triggers the Baseblock command to stop drive output. If you enter the baseblock
command, the motor will suddenly coast and the load will slip, which can cause serious injury or death.
V/f CL-V/f OLV CLV AOLV
V/f CL-V/f OLV CLV AOLV
V/f CL-V/f OLV CLV AOLV
V/f CL-V/f OLV CLV AOLV
V/f CL-V/f OLV CLV AOLV