YASKAWA CIPR-GA50C series, Техническое руководство

Страница: 632 / 766

12.8 H: Terminal Function Selection
632 YASKAWA SIEPC71061753A GA500 Technical Manual
ON : The DC bus voltage is less than the setting value of L2-05 .
OFF : The DC bus voltage is more than the setting value of L2-05 .
■
8: During Baseblock (N.O.)
Setting Value Function Description
8 During Baseblock (N.O.)
The terminal turns on during baseblock. When the drive is in baseblock, the drive output transistor stops switching and does not
make DC bus voltage.
ON : During baseblock
OFF : The drive is not in baseblock.
■
9: Frequency Reference from Keypad
Setting Value Function Description
9 Frequency Reference from
Keypad
Shows the selected frequency reference source.
ON : The keypad is the frequency reference source.
OFF :
b1-01 or b1-15 [Frequency Reference Selection 1 or 2] is the frequency reference source.
■
A: Run Command from Keypad
Setting Value Function Description
A Run Command Source
Shows the selected Run command source.
ON : The keypad is the Run command source.
OFF :
b1-02 or b1-16 [Run Command Selection 1 or 2] is the Run command source.
■
B: Torque Detection 1 (N.O.)
Setting Value Function Description
B Torque Detection 1 (N.O.)
The terminal activates when the drive detects overtorque or undertorque.
ON : The output current/torque is more than the torque value set with L6-02 [Torque Detection
Level 1] , or the level is less than the torque value set with L6-02 for longer than the time set with
L6-03 [Torque Detection Time 1] .
Note:
•
When L6-01 ≥ 5 , the drive will detect when the output current/torque is less than the detection level of L6-02 for longer than the time
set in L6-03 .
•
Refer to
“
L6: Torque Detection
”
for more information.
■
C: Frequency Reference Loss
Setting Value Function Description
C Frequency Reference Loss
The terminal activates when the drive detects a loss of frequency reference.
Note:
Refer to “ L4-05: Fref Loss Detection Selection ” for more information.
■
D: Braking Resistor Fault
Setting Value Function Description
D Braking Resistor Fault
The terminal activates when the mounting-type braking resistor is overheating or when there is a braking transistor fault.
■
E: Fault
Setting Value Function Description
E Fault
The terminal activates when the drive detects a fault.
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV