YASKAWA
SIEP C730600 83E CC-Link Technical Manual
21
◆
Option Connection Diagram
Figure 5.16 Using a Single Drive
*1
The option must be configured with a termination resistor. Refer to
Termination Resistor Connection on page 22
for more
information.
*2
Make sure that the FG terminal on the master drive is grounded properly.
*3
Connect the included ground wire for installations on 1000-series drives and GA500 drives.
The ground wire is not necessary for installation on GA700 or GA800 drives.
Figure 5.17 Using Multiple Drives
*1
The option must be configured with a termination resistor. Refer to
Termination Resistor Connection on page 22
for more
information.
*2
Make sure that the FG terminal on the master drive is grounded properly.
*3
Connect the included ground wire for installations on 1000-series drives and GA500 drives.
The ground wire is not necessary for installation on GA700 or GA800 drives.
◆
Communication Cable Specifications
WARNING
Fire Hazard. Tighten all terminal screws to the correct tightening torque. Connections that are too loose or too
tight can cause incorrect operation and damage to the drive. Incorrect connections can also cause death or serious injury from
fire.
Route the option wiring as specified by these procedures.
