YARDMAX YD8103, Руководство оператора

Страница: 18 / 28

Oil Filler
Oil Outlet
Adjusting Bolt
A
B
A
B
Jam Nut
Figure 8a
Figure 7
24
mm
TIGHTENING TRACKS
With use, tracks tend to loosen. When operating with loose tracks,
they tend to slip over the driving wheel causing it to jump its
housing, thus damaging wear to the housing.
To check track tightness, proceed as follows.
1. Set the machine on a flat surface with compact ground, or on
asphalt or pavement.
2. lift the machine and set it on blocks or supports rated for the
weight of the machine so that the tracks are approximately 4”
off the ground.
If the distance is greater, proceed as follows.
1. Use the tipping handle to tip the hopper and set it on blocks or
supports rated for the weight of the box.
2. loosen locknut A.
3. Tighten bolt b until the correct tightness is restored.
4. Secure bolt b by tightening locknut A thoroughly.
5. Return the hopper to its original position.
0.4” ~ 0.6”
LUBRICATION
The gearbox is pre-lubricated and sealed at the
factory. no need to lubricate until 50 hours use.
After first 50 hours use, change all the transmission
oil. Capacity is 1.5l.
For future use, just check the oil level every 50 hours
of working. If remove the drain plug, no oil flow out,
then add the oil.
Use portable tool lithium #0 grease such as lubriplate
6300AA , lubriplate GR-132, or Multifak, e.g. EP-O.
Transmission oil must be replace when engine is
stopped and warm by unscrewing filler cap and drain
plug. When oil is completely drained, replace filler cap
and fill up with fresh oil. (See
Figure 7 )
3. Measure the track midline vs. the horizontal line. The reading
must not be more than 0,4”~0,6”.
17
YD8103PM03 - 1802
|
Maintenance