If you only want to replace the rubber ring, proceed as follows:
1. Remove the eight screws which secure the friction wheel’s side
plates together.
2. Remove the rubber ring from between the plates.
3. Reassemble the side plates with a new rubber ring.
When reassembling the friction wheel assembly, make
sure that rubber ring is centered and seated properly
between the side plates. Tighten each screw only
one rotation before turning the wheel clockwise and
proceeding with the next screw on the other side of
the wheel. Repeat this process several times to ensure
the plates are secured with equal force between
90n.m(6 ft-lbs) and 130n.m(9 ft-lbs).
4. Slide the friction wheel assembly back onto the hex shaft. Make
sure the shift lever pin is in place in the bearing housing. Follow
the steps above in reverse order to reassemble components.
STORAGE
At the end of the season or if the snow blower will not be used for
30 days or longer, follow the storage instructions below.
1. Run the engine until the fuel lines and carburetor are empty
and it stops due to lack of fuel.
2. Remove the safety ignition key and allow the engine to cool.
3. Lubricate the machine as instructed.
4.
Clean the exterior of the engine and the snow blower
thoroughly.
5. Touch up all rusted or chipped paint surfaces; sand affected
areas before painting, and use a rust preventative to prevent
the metal parts from rusting.
6. Tighten all loose screws, bolts, and locknuts. Repair or replace
any damaged parts.
7. Cover the machine and store it in a clean, dry place out of the
reach of children.
Refer to the Engine Manual for information on
storing your engine.
Figure 19e
6. Remove the other bearing from the left side of the frame by
removing the snap ring.
7. Carefully position the hex shaft downward and to the left
8. Carefully sliding the friction wheel assembly off the shaft.
9. Follow the previous steps in reverse order to reassemble.
Snap Ring
Bearing
Figure 19c
Figure 19d
10
mm
13
mm
16
mm
19
mm
Rubber Ring
23
|
Service & Storage
30255JUS25M100.indd 23
2016/9/2 14:49:42
