16
SHUTTING DOWN AND STORAGE
1. (If you are not using detergent, go directly to Step 2.) When you have finished using the detergent dis-
pensing system, fill detergent tank with clean water to rinse the system clean. Squeeze the gun trigger
for one minute at low pressure so that all detergents remaining in system are thoroughly flushed out.
Remove detergent tank to empty the remaining water, and rinse it until it is thoroughly cleaned.
2. Turn off water supply and disconnect the garden hose from the faucet and the water inlet on the unit.
3. Squeeze the gun trigger for a few seconds to release any remaining water until water spray stops, turn
off unit immediately.
4. Unplug power cord from the power outlet and wrap it.
5. Disconnect the high-pressure hose from the gun wand and wrap it.
6. Engage gun trigger lock and disconnect the quick-connect wand from trigger handle, disassemble and
replace the spray tip to tip holder on the unit, insert the wand into the wand holder.
7. Store the machine and accessories in a room that does not reach freezing temperatures. Do not store
near furnace or other sources of heat as it may dry out the pump seals.
WARNING
Turn off water supply and squeeze trigger to depressurize the unit. Failure to do so could
result in personal injury due to discharge of high-pressure water.
Optimum Winterizing Procedure
Winterizing your pressure washer will help protect and prolong its life. We strongly recommend you follow
the below steps using *
Pressure Washer Pump Saver
.
This will keep the internal parts lubricated, protected from rust, and prevents the pump from freezing.
8. Connect Pressure Washer Pump Saver hose onto the water inlet.
9. Depress button on top of pump saver container.
10. Continue until fluid exits the high-pressure hose for 15 seconds.
11. Remove the hose from pump inlet (water inlet).
*Pressure Washer Pump Saver not included.
Fig. 21
