Yanmar ZT350 series, Руководство по установке

Страница: 70 / 80

PRE-DELIVERY
6-4 ZT350 Installation Manual
Pre-Delivery Preparation
© 2007 Yanmar Marine International
Fill the Power Trim Pump Fluid
Note: The power trim fluid does not require
changing unless it becomes
contaminated with water or debris.
Contact your authorized Yanmar Marine
dealer or distributor if the power trim fluid
needs to be changed.
1. Place the stern-drive in the full DOWN /
TRIM-IN position.
2. Unscrew and remove the fill cap
(Figure 6-4, (1)) assembly from the reservoir
(Figure 6-4, (3)) with specified fluid.
3. Add lubricant to bring the oil level to within the
MIN and MAX lines on the reservoir
(Figure 6-4, (2)) .
Figure 6-4
Figure 6-4
1 – Fill Cap Assembly
2 – MIN and MAX Lines
3 – Reservoir
4. Install the fill cap assembly.
Check the Stern-Drive Oil Level
Note: The oil level will rise and fall during
operation. Check the oil level before
starting, when the engine is cold.
1. Check the stern-drive lube oil level (Figure 6-5) .
Keep the oil level at or near the OPERATING
RANGE (full) line on the oil reservoir.
2. The oil level is low if it is below the ADD line on
the oil reservoir. Fill as needed with the
specified oil.
See Fill the Stern-Drive with Oil
below .
Figure 6-5
Figure 6-5
1 – Oil Reservoir
2 – ADD Line
3 – OPERATING RANGE Line
NOTICE: If any water is visible at the bottom
of the oil reservoir or appears at the oil fill /
drain plug and / or if oil appears discolored,
contact your authorized Yanmar Marine
dealer or distributor immediately. Both
conditions may indicate a water leak
somewhere in the stern-drive.
Dexron 3 Automatic Transmission Fluid
Where Used
Power Trim Pump
0006014
(2)
( 3 )
(1)
GL-5 Hypoid Gear Oil
Where Used
Oil Reservoir
0006336
(2)
( 3 )
(1)