Yanmar ViO80-1A, Руководство пользователя по эксплуатации и обслуживанию

Страница: 186 / 215

1 C
ONSERVATION
• Placing in conservation is intended to ensure the protection of the machine against corro-
sion from the environment and against minor damage that may occur during handling, trans-
port and storage.
• Return the machine to good condition before placing it in conservation.
1. Clean all the parts.
2. Apply greasing oil and grease to the machine's metal surfaces and replace the engine oil.
3. To avoid condensation in the fuel tank, drain the tank or fill it up.
4. Apply a small quantity of rust protector to the exposed parts of the hydraulic cylinder rod.
5. The battery must be disconnected. If the storage period exceeds one month, the battery
must be removed and stored in a special room.
6. Make sure the liquid in the cooling system has sufficient performance characteristics and is
appropriate for the machine's storage temperatures.
3 Recommended greases and fluids , page 144
If necessary, top up the water.
4.2 Checking and topping up the level of cooling fluid , page 86
WARNING
Do not open the bonnet during machine operation. Verification and topping off of the
various levels should be done when the engine is stopped and the temperatures are
brought back down.
7. Lock the joysticks and pedals using locking levers and pedal protectors.
Note
The machine rusts easily if it is left near the sea or in a place exposed to sea winds.
Apply rust protector to all the exposed parts of the piston rods and cover the machine
with a polyethylene sheet or oiled paper. Certain rust protection solvents dammage
rubber materials. Make sure you use an adapted rust protector.
WARNING
When you place the machine in an enclosed space, ventilate by opening the doors and
windows to avoid any gas intoxication.
169