Yanmar ViO38-6, Руководство пользователя по эксплуатации и обслуживанию

Страница: 89 / 202

2 Usage precautions
72
2.3.3 Working near electricity lines
DANGER
Working close to overhead electricity lines is very
dangerous and specific precautions must be taken.
• For this manual, you are considered as working near overhead electricity lines once the
equipment or your machine's load can reach the minimum distances indicated in the table
below.
• Follow these procedures to prevent any accident or injury :
– Wear shows with rubber or leather soles.
– Use a signaller to warn the operator when the machine is too close to an electrical line.
– If the machine is to enter into contact with a cable, the operator must not leave his seat.
– Warn all personnel on the ground to stay far enough away from the machine.
• To determine the voltage of the wires on the work site, contact the electricity production
company concerned.
Voltage (V) Minimum safety distance (m)
Electricity lines
≤ 50000
3
≥ 50000 5
WARNING
This table is provided for information only. Please refer to the regulations in force in
your country.
2.3.4 Working near obstacles
• When moving in a tunnel, under a bridge or when you are working in an area near tall obs-
tacels, drive the machine carefully to avoid knocking the boom, the arm or the accessory
against these obstacles.