Yanmar SV26, Руководство пользователя по эксплуатации и обслуживанию

Страница: 89 / 205

2 Usage precautions
72
2.3.3 Working near electricity lines
DANGER
Working close to overhead electricity
lines is very dangerous and specific
precautions must be taken.
• For this manual, you are considered as working near overhead electricity lines once the
equipment or your machine's load can reach the minimum distances indicated in the table below.
• Follow these procedures to prevent any accident or injury :
– Wear shows with rubber or leather soles.
– Use a signaller to warn the operator when the machine is too close to an electrical line.
– If the machine is to enter into contact with a cable, the operator must not leave his seat.
– Warn all personnel on the ground to stay far enough away from the machine.
• To determine the voltage of the wires on the work site, contact the electricity production com-
pany concerned.
Voltage (V) Minimum safety distance (m)
Transformer
≤ 100/200
2
≤ 6600 2
Transmission line
≤ 22000 3
≤ 66000
4
≤ 154000
5
≤ 275000
7
2.3.4 Working near obstacles
• When moving in a tunnel, under a bridge or when you are working in an area near tall obsta-
cels, drive the machine carefully to avoid knocking the boom, the arm or the accessory against
these obstacles.
2.3.5 Emergency stop and securing the machine
In case of an emergency stop of the machine, immediately put the accessory or load being hand-
led on the ground according to the following procedure:
In case of hose rupture or imminent dangerous phenomenon due to loss of control of the ma-
chine, release the machine controls and immediately lift the safety lever. The machine's power
circuits are cut, except the one controlling the blade.
Note
If necessary, move the ignition key to OFF to stop the engine.