Yanmar SD60, Руководство по эксплуатации

Страница: 26 / 44

PERIODIC MAINTENANCE
22
SD60 Operation Manual
MAINTENANCE
Maintenance programs described below are valid for the SD60, not the engine. For the
intervals and procedures for maintenance of the engine, refer to the operation manual and
maintenance of the engine.
Routine Maintenance
Scheduled Maintenance
Maintenance Schedule Maintenance to be Performed
At the beginning of the day Check the sail drive oil level.
Every two months of operation Check the battery connections and acid level.
Ensure that the clamps and the wiring connections are
secure.
Clean the clamps (every two operating months or
every 50 hours, according to the interval that occurs
first. In case of use in saltwater, the interval is reduced
to every 25 hours or 30 days of operation, according to
the interval that occurs first).
Interval Maintenance to be Performed
After the first 50 hours Change the oil.
Every 250 hours of operation or once a year,
according to the interval that occurs first. Change the oil.
Lubricate and check that the sea chest opens and
closes freely.
Every 500 hours or once a year, according to the
interval that occurs first. Lubricate the propeller shaft splines and tighten the
propeller nuts.
Check that pipe fitting are properly tight.
Check that in the grounding circuit (continuity) are not
loose or damaged connections.
Ensure that the electrical system fasteners are not
loose, damaged or corroded. Make sure that there are
not any loose, damaged or corroded wires and
connectors.
Check that the hose clamps on flexible pipes are
properly tight.
Apply an antifouling without copper material.
Replace every 7 years Replace the foot sealing membrane.
SD60_OPM.book 22 ページ ２０１７年１２月８日 金曜日 午後３時６分