Yanmar 4TNE98, Руководство по обслуживанию, Страница: 234 / 246

4TNV98 & 4TNE98 Diesel Engine Section 7. Starter Motor 232
Reassembly of Starter Motor
1. Apply the appropriate starter bendix grease
(obtain locally) to the pinion shaft. Reassemble
the pinion shaft
(Figure 11-27, (5)) , pinion clutch
assembly (Figure 11-27, (1)) , return spring
(Figure 11-27, (4)) and pinion stop (Figure 11-
27, (3)) . Reinstall the retaining ring (Figure 11-27,
(2)) in the groove in the pinion shaft. Slide the
piston stop over the retaining ring.
Figure 11-27
2. Reinstall the pinion clutch assembly into the
bearing retainer assembly.
3. Reinstall the bearing retainer assembly and
pinion assembly to the gear housing. Reinstall
and tighten the three M
4
bolts.
4. Apply a small amount of high temperature lithium
grease (obtain locally) to the sliding portions of
the shift lever
(Figure 11-28, (1)) . Reassemble
the torsion spring (Figure 11-28, (2)) , shift lever
and dust cover(s) (Figure 11-28, (3)) , plunger
(Figure 11-28, 4) and magnetic switch assembly
(Figure 11-28, (5)) .
Figure 11-28
5. Reassemble the magnetic switch assembly to
the gear housing. Pry the pinion away from the
gear housing to allow installation of the magnetic
switch assembly
(Figure 11-29) .
Figure 11-29
6. Secure the magnetic switch assembly to the gear
housing using the two M
6
bolts.
7. Carefully install the armature assembly
(Figure11-30, (1)) into the field coil assembly
(Figure11-30, (2)) .
Figure 11-30