Yanmar 1GM, Руководство по эксплуатации

Страница: 13 / 56

Note
1) Fix the wire to the cable clamp of the F.O. filter side.
2) Cable connector has M5 thread.
2-b)
After completing of wiring, check the following
points:
2-b)-1.
That the remote control lever and speed control lever
can be moved smoothly through the whole stroke.
2-b)-2
That the idle speed adjuster regulates the speed to
850-900 rpm, after all preparations for starting the
engine have been completed.
1. Cable clamp
3) Clutch Control
3-a)
Cone Clutch (for 1GM, 2GM, 3GMD)
3-a)-1.
Remove the spring joint from the operation lever.
3-a)-2.
With the spring joint disconnected from the operation lever,
move the operation lever forward and reverse, to make sure
that the strokes from the neutral position are the same.
3-a)-3.
Attach the spring joint to the operation lever 60mm from the shaft lever center.
The stroke from the neutral position moves through a distance of 24.4 to 35.Ohm. When the
spring joint is attached to the hole 52mm from the center of the shift lever, these strokes must
be 21.1-30.Ohm.
Note
The operation lever may not move smoothly when there is no lubrication oil in the clutch
case.