YANGZI YZ-S1, Инструкция по эксплуатации, Страница: 11 / 13

10
YZ-S1 Instruction Manual Instruction Manual
Common problems and Solutions
Problem reason Treatment
Large leaves or large garbage
particles are leaked during
sweeping
Working too fast Reduce the working speed
Brush height Adjust brush height
The bristles are deformed or
entangled with filaments
Remove the entanglement
The sweeper leaves dust on
the floor or dust from the
side shields
Filter clogged Clean the filter
Skin damage
Check the baffle and replace
it if damaged
Cleaning is not thorough,
leaving paper scraps, leaves
or other garbage
The lifting height of front
bumper is not correct
Adjust the skin guard link
The brush wears too fast
The brush is pressed too
low
Adjust brush height
Too much noise at work
The bristles are entangled
with filaments
Remove the entanglement
The bearing is broken Replace the bearing
Brush overpressure Reduce brush pressure
The brush does not rotate
when it works
The drive belt is damaged Replace the belt
Brush and fan motor do not
work
Motor damage Replace the motor
The electric dust shaker
does not work
Excessive motor load Check and reduce the load
The switch is broken Replace the fuse
The fuse is burnt out Check and reduce the load
Motor damage Replace the motor
Bearing wear Replace the bearing
The brush can work
normally and cannot run
normally
Problems of controller, fuse,
drive motor, governor and
brake switch
Check the input and output
voltage, alarm signal,
indicator light, fuse, drive
motor and connecting
circuit.