Yamato DG-450C, Инструкция по эксплуатации

Страница: 24 / 42

21
4. Operating procedures
Operating procedures (auto start operation)
This mode automatically starts fixed value operation after a certain time from its start set with the
timer.
However, operation does not stop automatically but needs to be stopped manually.
Procedures for auto start
operation
STOP
RUN
MEASURED TEMP.
℃
HEATER
RUN
SET TEMP.
TIMER
SUB MENU
1. Setting an operation start time
①
After confirming the temperature you want is set,
press the TIMER key to display characters AStr
on the measured temperature screen that
indicate auto start operation.
The set time is displayed blinking on the set
temperature screen.
②
Set a time you want using the
▼▲
keys.
Pressing the
▼▲
keys makes the set time blink. The
time is determined when blinking stops.
About the timer function
The maximum time that can be set for the timer is 999 hours
50 minutes.
Up to 99 hours 59 minutes, time can be set in minutes.
One hundred hours and over are set only in 10 minutes.
Keep the
▼▲
keys pressed to continuously change set
time and you can quickly reach the time you want. Press the
▼▲
keys once at a time for fine adjustment.
STOP
RUN
MEASURED TEMP.
℃
HEATER
RUN
SET TEMP.
TIMER
SUB MENU
2. Starting timer operation
When the time you want is set, press the RUN/STOP key
for about one second while characters AStr that
indicate auto start operation are displayed on the
measured temperature screen and the set time on the set
temperature screen.
Timer starts counting when the RUN/STOP key is
pressed.
Display on the measured temperature screen switches
from set time display to remaining time display.
STOP
RUN
MEASURED TEMP.
℃
HEATER
RUN
SET TEMP.
TIMER
SUB MENU
3. Stopping and ending timer operation
Operation automatically starts at the set time and the
RUN lamp comes on.
To stop operation, press the RUN/STOP key for approx.
one second to end the timer operation mode. The screen
switches to the initial setting screen.
① ②