ST3000 Smart Transmitter Series 900 Electronic Differential Pressure/Pressure Transmitter
2-1
Chapter 2 :
Quick Start Reference
2-1 : Introduction
This section assumes that the ST3000 Smart Transmitter has been installed and wired
correctly, and is ready to be put into operation. It also assumes that you are somewhat
familiar with using the SFC and that the transmitter has been configured correctly for
your application. If the transmitter has not been installed and wired, you are not famil-
iar with SFC operation, and/or you do not know if the transmitter is configured cor-
rectly, please read the other sections of this manual before operating your transmitter.
This section provides a list of typical start-up tasks and tells you where you can find
detailed information about performing the task.
2-2 : Getting ST3000 Smart Transmitter On-Line Quickly
Quick start-up tasks
Table 2-1 lists common start-up tasks for an ST3000 Smart Transmitter using an SFC
and gives an appropriate section in this manual to reference for more information
about how to do the task. The start-up tasks are listed in the order they are commonly
completed.
Table 2-1 Start-up Tasks Reference
Task
Description
Reference Section
1
Connecting SFC
5-1-1
2
Setting Tag No. and Checking Specifications
5-2
3
Starting Communications
5-2-1
4
Setting Tag No.
5-2-2
5
Checking Output Format
5-2-3
6
Checking Display Setting
5-2-4
7
Checking Engineering Unit of Measured Pressure
5-2-5
8
Checking Low and High Limits of Setting Range
5-2-6
9
Checking Damping Time Constant
5-2-7
10
Checking Sealed Liquid Temperature Correction
Function Setting
5-2-8
