Perio
d
ic maintenance an
d
a
d
justment
7-8
7
6. Refill with the specified amount of
the recommended transmission
oil.
NOTICE
ECA10453
In or
d
er to prevent clutch slip-
pa
g
e (since the transmission oil
also lu
b
ricates the clutch),
d
o
not mix any chemical a
dd
itives.
Do not use oils with a
d
iesel
specification of “CD” or oils of a
hi
g
her quality than specifie
d
. In
a
dd
ition,
d
o not use oils la
b
ele
d
“ENERGY CONSERVING II” or
hi
g
her.
Make sure that no forei
g
n mate-
rial enters the transmission.
7. Check the O-ring for damage, and
replace it if necessary.
8. Install and tighten the transmis-
sion oil filler cap and its O-ring.
9. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
EAU20071
Coolant
The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
EAUM1296
To check the coolant level
1. Place the vehicle on a level sur-
face and hold it in an upright posi-
tion.
TIP
The coolant level must be
checked on a cold engine since
the level varies with engine tem-
perature.
Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Remove the radiator cap and
check the coolant level in the radi-
ator.
WARNING! Never attempt
to remove the ra
d
iator cap
when the en
g
ine is hot.
[EWA10382]
Ti
g
htenin
g
torque:
Transmission oil drain bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
Recommen
d
e
d
transmission oil:
Motor oil SAE 10W-30 type SE or
higher or Gear oil SAE 85W GL-3
Oil chan
g
e quantity:
0.50 L (0.53 US qt, 0.44 Imp.qt)
1. Radiator cap
1
UBR880E0.book Page 8 Friday, February 16, 2018 8:32 AM