YVC-1000MS User's Manual
31
Select whether to output the incoming sound through only the built-in speaker, only external speakers, or both the
built-in speaker and external speakers.
1
Hold down the and - buttons (
) for 2 seconds or more at the
same time.
The and - buttons (
) flash green.
The selected speaker is shown on the level indicator, and the voice guidance prompts you to determine the
speaker.
2
Press the (
) button or volume - (
) button to change the required
speaker.
If the speaker is changed, the voice guidance notifies the user of information about the new speaker.
If the (
) button or volume - (
) button is not pressed for 6 seconds or more, the product returns to
the normal mode.
Both the built-in speaker and external speakers cannot be disabled.
Selecting a speaker
Indicator pattern (
: ON,
: OFF)
Speaker output
The sound is output only from the built-in speakers.
The sound is output from both the built-in speakers and external speakers.
The sound is output only from external speakers.
Operation
Changed contents
Press the button (
).
Switches whether to enable or disable the output of external speakers.
Press the volume - button (
).
Switches whether to enable or disable the output of the built-in speaker.
Level indicator
The table below shows indicator patterns viewed from this side.
and - buttons
