Yamaha YRS-1100, Инструкция по эксплуатации

Страница: 15 / 455

13
En
Initial settings
P
RE
P
ARATI
O
N
P
L
AY
BAC
K
S
E
TTI
NG
S
TR
OUB
LES
HOO
TI
NG
A
B
OU
T
T
H
IS
U
N
IT
En
g
lis
h
CO
NNE
CTI
O
N/
IN
IT
IA
L
S
E
T
T
IN
G
S
The screen below is displayed after connecting
IntelliBeam microphone to the unit.
1) 2)
4
Press ENTER key to start the AUTO
SETUP procedure and then leave the room
within 10 seconds.
3)
The setup screen automatically changes during the AUTO
SETUP procedure.
If AUTO SETUP procedure is complete, this unit rings
the chimes.
4)
AUTO SETUP
(PREPARATION & CHECK)
Please connect the MIC.
Please place the MIC at least
1.8m/6ft away from SoundPro-
jector. The MIC should be set
at ear level when seated.
Measurement takes about 3min.
After [ENTER] is pressed,
please leave the room.
[ENTER]:Start [RETURN]:Cancel
The best setting may not be done if you are in the room. Prepare to
leave the room in 10 seconds after pressing
ENTER in step 4.
Note
MEASUREMENT COMPLETE.
BEAM MODE :5Beam/Plus2
SUBWOOFER :Yes
[ENTER]:Save set-up.
[RETURN]:Do not save set-up.
XXXXXXXX SHOW RESULT XXXXXXXXXX
Will begin in 10 sec.
Please leave the room.
---------
AUTO SETUP START
[RETURN]:Cancel
(After 3 min.)
5
Press ENTER key to confirm the
results.
5)
The measurement result is saved.
6
Remove the IntelliBeam microphone.
Initial screen appears.
6)
Keep the IntelliBeam microphone in a safe place.
The measurement results are stored in the internal
memory of this unit until you run the AUTO SETUP
procedure again or configure the settings manually.
You can save the several measurement result using
memory setting function (
☞
p. 16).
AUTO SETUP COMPLETE
Please remove the MIC
from Sound Projector
and the listening position.
• If an error occurs, an error buzzer sounds and an error message is
displayed. For details on error messages, see “Error messages for
AUTO SETUP” (
☞
p. 15).
• If “ENVIRONMENT CHECK:Failure” is displayed, refer to “Error
messages for AUTO SETUP” (
☞
p. 15), press RETURN key, and
then run the AUTO SETUP procedure again.
• Depending on the environment of your listening room, the beam
angles of front right and left and surround left and right may be set to
the same value even if “BEAM MODE :5 Beam” is displayed as a
result.
If you do not want to reflect the results, press RETURN key.
When AUTO SETUP is performed from SETUP MENU, menu selection
screen of SETUP MENU appears.
4)
y
5)
y
6)
y