Yamaha XVS6501997, Руководство по обслуживанию

Страница: 252 / 327

6-52
SHAFT DRIVE
CHAS
*****************************************************
*****************************************************
CAUTION:
NOTE:
Inspection notes
1. Investigate any unusual noises.
The following noises may indicate a me-
chanical defect:
a.
A rolling “rumble” during coasting, accel-
eration, or deceleration. The noise in-
creases with rear wheel speed, but does
not increase with higher engine or trans-
mission speeds.
Diagnosis:
Possible wheel bearing dam-
age
b. A whining noise that varies with accelera-
tion and deceleration.
Diagnosis:
Possible incorrect reassemb-
ly, too little gear lash
Insufficient gear lash is extremely destruc-
tive to the gear teeth. If a test ride following
reassembly indicates this condition, stop
riding immediately to minimize gear dam-
age.
c. A slight “clunk” evident at low speed opera-
tion. This noise must be distinguished from
normal motorcycle operation.
Diagnosis:
Possible broken gear teeth
Stop riding immediately if broken gear teeth
are suspected. This condition could result
in a locking of the shaft drive assembly,
causing loss of control of the motorcycle
and possible injury to the rider.
2. Inspect:
Drained oil
Drained oil contains a large amount of
metal particles
Check the bearing for
seizure.
A small amount of metal particles in the oil is
normal.