PERIODIC MAINTENANCE AND ADJUSTMENT
7-37
7
EAU24212
Replacing a turn signal light
bulb
1. Remove the turn signal lens by re-
moving the screws.
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws.
NOTICE:
Do not over-
tighten the screws, otherwise
the lens may break.
[ECA10681]
EAU31963
Replacing a license plate light
bulb
1. Remove the license plate light unit
by removing the bolts.
2. Remove the license plate light
socket (together with the bulb) by
turning it counterclockwise, and
then pulling it out.
3. Remove the burnt-out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in, and then turn
it clockwise until it stops.
6. Install the license plate light unit by
installing the bolts.
1. Screw
1
1. Bolt
1. Bulb
U1BH10E0.book Page 37 Tuesday, December 8, 2009 4:47 PM
