Yamaha XT1200Z(Z) 2010, Руководство по обслуживанию, Страница: 578 / 616

ABS (ANTI-LOCK BRAKE SYSTEM)
8-129
EAS23P1056
[D-1] DELETING THE FAULT CODES
1. Remove the protective cap, and then connect
the test coupler adapter “1” to the ABS test
coupler “2”. Refer to “[B-5] MALFUNCTIONS
ARE CURRENTLY DETECTED” on page
8-99.
2. Set the main switch to “ON”.
Fault codes will be indicated by the ABS
warning light.
3. Set the engine stop switch “1” to “ ”.
NOTICE
ECA23P1051
If the start switch is pushed without setting
the engine stop switch to “
”, the starter
motor gears or other parts may be damaged.
4. Without operating the brake lever, push the
start switch “2” at least 10 times in 4 seconds
to delete the fault codes.
5. The ABS warning light flashes in 0.5-second
intervals while the fault codes are being delet-
ed.
6. Set the main switch to “OFF”.
7. Set the main switch to “ON” again.
TIP
If the ABS warning light does not flash in 0.5-
second intervals, the malfunctions have not
been repaired. Diagnose the malfunctions using
the fault codes.
8. Set the main switch to “OFF”.
9. Disconnect the test coupler adapter from the
ABS test coupler, and then install the protec-
tive cap onto the ABS test coupler. Deleting
the fault codes is now finished.
TIP
Do not forget to install the protective cap onto
the ABS test coupler.
NOTICE
ECA23P1052
Since the fault codes remain in the memory
of the ABS ECU until they are deleted, always
delete the fault codes after the service has
been completed.
EAS23P1057
[D-2] DELETE FUNCTION TEST
1. Place the vehicle on the centerstand.
2. Disconnect the ABS ECU coupler “1”.
TIP
While pushing the portion “a” of the ABS ECU
coupler, push the lock lever down to release the
lock.
NOTICE
ECA23P1053
Do not use a tool to disconnect the ABS ECU
coupler.
3. Remove the coupler cover “1” from the ABS
ECU coupler.
TIP
While pushing the portion “a” of the coupler cov-
er, remove the cover.
2
1
1
2
1
a