Yamaha XT1200Z(Z) 2010, Руководство по обслуживанию, Страница: 418 / 616

MIDDLE GEAR
5-123
11.Measure:
• Middle gear backlash
Out of specification
→
Refer to “MEASUR-
ING THE MIDDLE GEAR BACKLASH” on
page 5-121.
EAS25930
ALIGNING THE MIDDLE GEAR
TIP
Aligning the middle gear is necessary when any
of the following parts are replaced:
• Crankcase
• Middle drive pinion gear
• Middle driven pinion gear
• Middle driven pinion gear bearing housing
1. Select:
• Middle drive pinion gear shim(s) “1”
• Middle driven pinion gear shim(s) “2”
TIP
Select the middle driven pinion gear shim(s) “2”
by calculating the middle drive pinion gear shim
thickness and then measuring the middle gear
backlash.
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Position the middle gears with the appropri-
ate shim(s) that has had its respective thick-
ness calculated from information marked on
the upper crankcase, middle driven pinion
gear, and bearing housings.
b. To find middle drive pinion gear shim thick-
ness “A”, use the following formula.
“a”= a numeral on the middle drive pinion
gear bearing housing, to be divided by 100
and added to “14.00”
“b”= 52.20
“c”= a numeral on the upper crankcase, to be
divided by 100 and added to “66.00”
Example:
If the middle drive pinion gear bearing hous-
ing is marked “57”
“a” is 14.57 (i.e., 14.00 + 0.57 = 14.57)
“b” is 52.20
If the upper crankcase is marked “18”
“c” is 66.18 (i.e., 66.00 + 0.18 = 66.18)
“A” = 14.57 + 52.20 - 66.18 - 0.1 = 0.49
Round off to the hundredths digit and select
the appropriate shim(s).
TIP
In the above example, the calculated number is
0.49. The chart instructs you to round off the 9 to
10. Thus, the shim thickness is 0.50 mm.
A. Middle drive pinion gear shim thickness
B. Middle driven pinion gear shim thickness
b a
A
c
g
f
d
e
B
1
2
Middle drive pinion gear shim thickness
“A” = “a” + “b” - “c” - 0.1
a
c