Instrument an
d
control functions
4-5
4
WARNING
EWA16041
If the ABS warnin
g
li
g
ht
d
oes not
g
o
off after travelin
g
at a spee
d
of 10
km/h (6 mi/h) or hi
g
her, or if the
warnin
g
li
g
ht comes on or flashes
while ri
d
in
g
, the
b
rake system re-
verts to conventional
b
rakin
g
. If ei-
ther of the a
b
ove occurs, or if the
warnin
g
li
g
ht
d
oes not come on at
all, use extra caution to avoi
d
possi-
b
le wheel lock
d
urin
g
emer
g
ency
b
rakin
g
. Have a Yamaha
d
ealer
check the
b
rake system an
d
electri-
cal circuits as soon as possi
b
le.
EAU78591
Traction control system in
d
icator
li
g
ht “TCS”
This indicator light will flash when trac-
tion control has engaged.
If the traction control system is turned
off, this indicator light will come on.
(See page 4-17.)
TIP
When the vehicle is turned on, the light
should come on for a few seconds and
then go off. If the light does not come
on, or if the light remains on, have a
Yamaha dealer check vehicle.
EAUM3621
Immo
b
ilizer system in
d
icator
li
g
ht “
”
When the key is turned to “OFF” and
30 seconds have passed, the indicator
light will flash steadily to indicate the
immobilizer system is enabled. After 24
hours have passed, the indicator light
will stop flashing, however the immobi-
lizer system is still enabled.
The electrical circuit of the indicator
light can be checked by turning the key
to “ON”. The indicator light should
come on for a few seconds, and then
go off.
If the indicator light does not come on
initially when the key is turned to “ON”,
if the indicator light remains on, or if the
indicator light flashes in a pattern (if a
problem is detected in the immobilizer
system, the immobilizer system indica-
tor light will flash in a pattern), have a
Yamaha dealer check the vehicle.
TIP
If the immobilizer system indicator light
flashes in the pattern, slowly 5 times
then quickly 2 times, this could be
caused by transponder interference. If
this occurs, try the following.
1. Make sure there are no other im-
mobilizer keys close to the main
switch. Other immobilizer system
keys may cause signal interfer-
ence and prevent the engine from
starting.
2. Use the code re-registering key to
start the engine.
3. If the engine starts, turn it off, and
try starting the engine with the
standard keys.
4. If one or both of the standard keys
do not start the engine, take the
vehicle and all 3 keys to a Yamaha
dealer to have the standard keys
re-registered.
UBAEE0E0.book Page 5 Tuesday, December 10, 2019 2:42 PM