Operation an
d
important ri
d
in
g
points
7-2
7
EAU78231
Startin
g
the en
g
ine
NOTICE
ECA10251
See pa
g
e 7-1 for en
g
ine
b
reak-in in-
structions prior to operatin
g
the ve-
hicle for the first time.
In order for the ignition circuit cut-off
system to enable starting, the side-
stand must be up. (See page 5-25.)
1. Turn the main switch on and make
sure that the stop/run/start switch
is set to “
”.
The following warning lights and
indicator lights should come on for
a few seconds, then go off.
Engine trouble warning light
Traction control system indi-
cator light
Smart key system indicator
light
TIP
The ABS warning light should come on
and stay on until the vehicle reaches a
traveling speed of 10 km/h (6 mi/h) or
higher.
NOTICE
ECA22510
If a warnin
g
or in
d
icator li
g
ht
d
oes
not work as
d
escri
b
e
d
a
b
ove, see
pa
g
d
in
g
warnin
g
an
d
in
d
icator li
g
ht circuit
check.
2. Close the throttle.
3. While applying the front or rear
brake, push the “
” side of the
stop/run/start switch. Release it
when the engine starts.
TIP
If the engine does not start, release the
start switch after 5 seconds. Before
pressing the start switch again, wait 10
seconds to allow battery voltage to re-
store.
NOTICE
ECA11043
For maximum en
g
ine life, never ac-
celerate har
d
when the en
g
ine is
col
d
!
EAU78221
TIP
This model is equipped with a lean an-
gle sensor to stop the engine in case of
a turnover. In this case, the engine
trouble warning light will come on but
this is not a malfunction. Before re-
starting the engine, turn the main
switch off and then back on to reset the
engine trouble warning light. Failing to
do so will prevent the engine from
starting even though the engine will
crank when pushing the start switch.
UB5X10E0.book Page 2 Thursday, May 27, 2021 8:55 AM